Hydraulic winch is especially designed for heavy-duty lifting, pulling and towing operations. It is a good choice when an electric winch machine cannot match your operating and performance conditions. Powered by a hydraulic system, this type of winch has more strength than an electric power winch, thus it is ideal for the most demanding tasks in construction, mining and marine. Our winches can be designed and built into any size and form to meet your application demands.

Hydraulic Planetary Winches are tested and certified to operate in temperatures from -40° F to 120° F. Our winches offer easy, fast free spooling with only 132 lbs (60kg). resistance at -35ºF and can be operated by air or manually, providing fast line payout and reducing wear on components. Our Winch Hydraulic Planetary Winches are manufactured to meet ISO 9001 and CE standards .

boat winch, crane winch, excavator winch, bulldozer winch,tractor winch, truck winch, pile rig winch, dredger winch,etc. The following is some of our winch used on application.

1.Worm gear transmission or planetary transmission

2.Single or double drum

3.Grooved drum for better rope spooling on the drum

4.Drum guard

5.Drum pressure roller for uniform winding

6.Limit switches

7.Emergency hand crank

8.Proportional control valves or hydraulic power packs

Hydraulic winch is also called electro-hydraulic winch, which is driven by a hydraulic pump by an electric motor, and the generated oil pressure drives the oil motor, and then the winch runs through a reducer (or without a reducer).

1, winch installation location and direction, allowing the drum axis as the center, any conversion position.

2, install the base plate bolt hole location installation. Note: The number and size of fixing bolts must comply with the requirements and must not be reduced or replaced with small diameter bolts.

3, winch floor installation, must be fixed and reliable, shall not be bent in use, the installation of the flatness of not more than 0.5mm,

otherwise it will affect the smooth operation of the winch,

4, after the winch is installed, the base contact surface should be level and force evenly.

5, to ensure that the vertical axis of the drum and the pulley vertical, vertical axis of the drum and the pulley angle of not more than 1.5 degrees.

6, winch oil control valve should be a spring reset H-type three-way four-way valve, control valve installation location, according to the

needs of the operation on the appropriate location.

7, brake valve (ie, sequence valve) to open the pressure should be between 6 ~ 8Mpa, winch factory, the manufacturer has been

adjusted, please do not change.

8, winch use a wide range of occasions, single-use, the hydraulic system pressure, flow must be consistent with the requirements of

the instructions, otherwise it will affect the service life of the winch. According to the needs of users, the factory can provide supporting

power source, control valves and related pipelines.

9, under normal circumstances, when the operator facing the motor back to the operator relatively close to the port to enhance (into) the oil

port. This port can be based on the specific operator habits. But once you decide not to change it.

10, Before formal use, you must carefully check the connection of the pipeline, lubricating oil level, ventilation holes, system pressure,

etc. After everything is normal, turn back and forth for 2 minutes.

11, winch rope fixed, the lifting, the rope must be wound on the drum first 5 laps or more.

12, do not stampede, collision winch metal pipelines and joints, so as not to damage the winch.

13, winch lifting heavy objects, pay special attention to observe the motor drain port pressure gauge, such as back pressure over

1.4MPa, the system must be carefully back to the oil return line to ensure smooth.